Currently the setting are such that the code will get annotated in the "Annotated_Project_OOD3" folder.
Annotated code can be compiled and run through the compile.bat and run.bat which will created programatically in the AnnotateCode Folder itself.


To RUN annotated following steps are required.
   ===========================================	
- build one visual studio project and include all the annotated files in that project.
- also add/include all the 6 files in the same visual studio project i.e. SysTime.cpp & .h, tracer.cpp & .h, OverloadNewAndDelete.cpp & .h which you 
  can found in the Helper folder which is in the root folder.
- compile it through visual studio, then you will get project_name.sln.
- compile it again through compileBydevenv.bat 
- run it.
- wait for few minutes because this time the output will near about 100MB so it will take time.

TO SKIP THESE ABOVE STATED PROCESS:
===================================
I HAVE ALREADY DONE THIS ABOVE STATED THINGS FOR YOU. JUST COMPILE AND RUN. YOU CAN ALSO CROSS VERIFY BY DOING ALL THE ABOVE STEPS.
===================================================================================================================================


TO CHECK RULES PLEASE run run.bat, it will test my rules on my OOD_PROJECT_1, OOD_PROJECT_2, OOD_PROJECT_3 and few test files. (PLEASE REFER RUN.BAT in root folder)

THANKS,

PRATEEK MALOO.